Use this wizard page to configure static Internet Protocol version 4 (IPv4) address pools that are used to provide addresses to virtual private network (VPN) and dial-up remote access clients. Only IPv4 addresses can be configured this way. To configure Internet Protocol version 6 (IPv6) addresses, you must use DHCPv6.

  • To create a new range, click New, and then provide a starting and ending address, or a starting address and the number of desired addresses. If you specify the desired number of addresses, RRAS will calculate the ending address for you.

  • To modify an existing range, click Edit.

  • To remove a range from use, click Delete.

Additional references

Table Of Contents