The following procedures are used to configure the Routing and Remote Access service (RRAS).
- Install RRAS
- Open the RRAS MMC Snap-in
- Configure a Dial-Up Remote Access Server
Configure a Firewall for VPN Traffic (https://go.microsoft.com/fwlink/?linkid=140709)- Configure the Way RRAS Assigns IP Addresses to VPN Clients
- Configure Logging Levels for RRAS
- Configure Network Access Protection Enforcement for VPN
- Configure Ports for Remote Access
- Configure RRAS with a Computer Authentication Certificate
Configure Static Packet Filters (https://go.microsoft.com/fwlink/?linkid=140713)- Configure the IPv4 DHCP Relay Agent
- Configure the IPv6 DHCP Relay Agent
- Configure TCP/IP on the RRAS Server
- Create a Demand-Dial Interface
- Create a Static Route
- Enable and Configure NAT
- Enable and Configure RIP
- Enable IPv6 Remote Access
- Enable RRAS as a LAN and WAN Router
- Enable RRAS as a VPN Server
- Enable RRAS as a VPN Server and a NAT Router
- Remove RRAS from a Server
- View Information in RRAS