You can install DirectAccess by using the Add Features wizard in Server Manager or in the Initial Configuration Tasks window.
A associação ao grupo Administradores local, ou equivalente, é o mínimo necessário para concluir este procedimento.
 | To install DirectAccess |
Perform one of the following two steps to open the Add Features Wizard:
- Open Gerenciador do Servidor. In the main window, under Features Summary, click Add features.
- In the Initial Configuration Tasks window that appears when you first log on, under Customize This Server, click Add features.
- Open Gerenciador do Servidor. In the main window, under Features Summary, click Add features.
On the Select Features page, select DirectAccess Management Console.
In the Add Features Wizard window, click Add Required Features.
On the Select Features page, click Next.
On the Confirm Installation Selections page, click Install.
On the Installation Results page, review the status, and then click Close.
 | Observação |
After you complete the installation, DirectAccess Management Console appears in the list of features in Server Manager. You must now run the DirectAccess Setup wizard to configure your server for DirectAccess. For more information, see Checklist: Install and Configure Single-Server DirectAccess and Use the DirectAccess Snap-in to Configure DirectAccess. |