The information displayed under RIP in the RRAS MMC snap-in includes the interfaces that can send and receive router table updates by using the Routing Information Protocol (RIP).

By default, RIP does not appear under IPv4 in the MMC snap-in until you install it.


If you use multiple IP routing protocols, configure only a single routing protocol per interface.

To install RIP
  1. In the RRAS MMC snap-in, expand IPv4, right-click General, and then click New Routing Protocol.

  2. In the New Routing Protocol dialog box, select RIP Version 2 for Internet Protocol, and then click OK.

  • To configure server-wide settings for RIP, right-click RIP, click Properties, and then configure the settings on the IPv4 - RIP – Properties page.

  • To configure an interface to use RIP, right-click RIP, click New Interface, select the interface on which you want to enable RIP, and then click OK.

  • To configure RIP settings for a single interface, click RIP. In the list of RIP interfaces, right-click the interface, and then click Properties to display the IPv4 - RIP - Interface – Properties page.

Additional references

Table Of Contents