This topic provides a procedure that you can use to change the resources used by a device.
 | Caution |
|
Changing resource settings improperly can disable your hardware and cause your computer to malfunction or become inoperable. Resource settings should be changed only by users who have expert knowledge of computer hardware and hardware configuration settings. |
Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.
 | To change resource settings for a device |
Double-click the type of device you want to change.
Double-click the specific device you want to change. If the device has resources settings that you can change, the Resources tab will appear in the dialog box.
Click the Resources tab, and then clear the Use automatic settings check box. This check box might be unavailable if you cannot assign a specific resource to the device.
In Setting based on, click the hardware configuration you want to change.
In Resource settings, under Resource type, click the resource type you want to change. Your choices are as follows:
-
Direct memory access (DMA)
-
Interrupt request (IRQ)
-
Input/output (I/O) port
-
Memory address
-
Direct memory access (DMA)
Click Change Setting, and then type a new value for the resource type.
Repeat steps 2 through 7 as necessary.
Additional considerations
 | Important |
|
Make sure that the new settings do not conflict with any other devices. If you have any device conflicts, they appear on the Resources tab under Conflicting device list. |
-
Use automatic settings is not enabled for devices that have no other settings that you can configure. It is also not enabled for devices that are controlled by Plug and Play resources and should not be changed by the user.
-
You should need to assign resources manually only for some older Industry Standard Architecture (ISA) and Plug and Play basic input/output system (BIOS) devices. It is not usually necessary for you to change resource settings because resources are automatically allocated by the system when the hardware is installed.